BzMiner 100.81 pushes the RX 9070 XT past 150 TH/s on Pearl: what changes for AMD miners

BzMiner v100.81 came out on 13 November 2026, two days after v100.80. v100.80 improved Pearl on NVIDIA, while this one targets AMD cards on Pearl: the developer reports higher hashrate on RDNA 3 and RDNA 4 and says the RX 9070 XT can now go above 150 TH/s. The figures below come from the v100.81 release notes, not from independent tests.

Developer test results on Pearl

Each profile ran for 10 minutes on a public pool with no rejected or stale shares and no failed proofs. Power is board power as reported by the driver, not wall power.

  • RX 9070 XT, max hashrate (core voltage offset -100): 153.60 TH/s at 315.8 W, 0.486 TH/J.
  • RX 9070 XT, max efficiency (power limit 221 W, voltage offset -100): 131.52 TH/s at 221.0 W, 0.595 TH/J.
  • RX 7900 XTX, max hashrate (voltage offset -100): 62.85 TH/s at 389.0 W, 0.162 TH/J.
  • RX 7900 XTX, max efficiency (power limit 350 W, core clock offset -500, voltage offset -100): 54.48 TH/s at 257.7 W, 0.211 TH/J.

In the efficiency profiles the RX 9070 XT keeps about 86% of its top hashrate at about 70% of the power, and the RX 7900 XTX keeps about 87% at about 66%. On Pearl the newer RDNA 4 card is roughly 2.4 times faster than the RX 7900 XTX while drawing less power.

Other changes in v100.81

  • New --oc-core-voltage-offset support for AMD cards, the setting used in all four test profiles.
  • Higher Pearl hashrate on NVIDIA CMP 170HX and better Quantus results on RTX 50 cards.
  • The miner no longer resets overclock settings when none are set in the config or command line.
  • Dual mining of C29 with cn/gpu no longer fails on 6 GB cards, and high CPU and RAM usage during GPU mining is fixed.

SRBMiner-Multi also tunes Pearl for AMD

On the same day SRBMiner-Multi 3.8.8 also listed pearlhash improvements for AMD RDNA 3 and RDNA 4, plus efficiency gains on NVIDIA RTX 30, 40 and 50, fixes to its efficiency fine-tuner and a 0% developer fee on FishHash. The developer gave no AMD figures, so compare both miners on your own card.

What AMD owners should do

If you mine Pearl on an RX 9070 XT or RX 7900 XTX, try v100.81 with a negative core voltage offset and a power limit, then compare accepted hashrate and wall power over a longer run than ten minutes. Settings that work on the developer's cards may need a softer offset on yours, so watch for crashes and invalid shares after each change.

#BzMiner#Pearl#RX 9070 XT#RX 7900 XTX#AMD#RDNA 4#SRBMiner-Multi#GPU mining
Nov 16, 2026, 10:24 AM