텔레그램 뉴스 채널 암호화를 구독하고 모든 최신 동향을 확인하세요.
채굴, 에어드롭, 거래, 가이드, 기술, 투자 - 모든 것이 있습니다!!!
RGminer 1.1.6 cuts Pearl power by 12% on RTX 20 and CMP 40HX/50HX cards
RGminer 1.1.6 came out on 14 November 2026, three days after version 1.1.5. The main change is for older NVIDIA cards mining Pearl: on the RTX 20 and GTX 16 series and on CMP 40HX / 50HX, a new kernel is now on by default and, according to the developer, draws 12% less power at the same hashrate. All figures below come from the RGminer 1.1.6 release notes, not from independent tests.
What 1.1.6 changes on Pearl
- RTX 20, GTX 16, CMP 40HX / 50HX: the new --kernel 2 is selected by default. Power is 12% lower with the core clock about 3-4% higher, and the hashrate stays the same with memory at 405 MHz.
- RTX 30, CMP 70HX / 90HX: hashrate +0.53%, energy efficiency +6.45%.
- RTX 40: hashrate +0.35%, power −2.77%, efficiency +3.21%.
- RTX 50: power −6%.
In the developer's table the RTX 2080 gives about 76.5 TH/s on Pearl at roughly 140-146 W, with a 1716 MHz core and 405 MHz memory. The RTX 4090 gives about 318.8 TH/s at roughly 260-273 W. These are the author's settings for specific cards, so treat them as a starting point and check accepted shares and wall power on your own rig.
The update also fixes startup on older drivers and on some hardware setups, fixes autotuning bugs, adds a HiveOS reboot notice during farm tuning ("GPU is hungry, rebooting the system") and fixes the Windows unlock installer and the Windows binary failing to start.
What came a few days earlier in 1.1.5
- Smart undervolting (--smart-tune on, off by default). It tunes each card step by step, about 5-15 MHz of core offset per step. A session usually takes 30-90 minutes. Do not raise clocks after tuning: stop the miner, change the settings and start it again.
- Memory control on Linux (--mem-control on by default). The miner picks a memory profile for the algorithm and the card, including 405 / 810 MHz modes, and restores the settings when it stops. If another miner left P-state changes behind, a reboot may be needed after the upgrade. Explicit OC settings in the command line take priority.
- Built-in referral scheme: rigs of an invited user send every tenth developer fee share to the referrer's wallet. The fee itself does not grow.
- Pearl efficiency +3-8% on RTX 20-50 depending on the architecture, Quantus hashrate +1.7% to +5% depending on the series, new NOID support, Exfer removed.
What miners should keep in mind
The developer fee on Pearl stays at 2%. RGminer is an NVIDIA-only miner. For owners of RTX 20 and CMP 40HX / 50HX cards on Pearl, 1.1.6 is worth a test: the gain is in power, not hashrate, so compare consumption before and after at the same clocks. If you used --mem-control with custom memory settings, check that the miner is not overriding them.